SFA 1203 Lecture 4: Fuji emulsion lift workshop

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-title

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-icon

WHAT’S MOREinstant-university_yellow-border

In this lecture, you will learn about how to do emulsion lift using Fuji instant films. It can be made using FP-100C and 8×10 films. In fact, the process is pretty similar to the Polaroid / Impossible film. The biggest difference between the two is their emulsions. Extra works are needed during the process.

 

WHAT YOU NEEDinstant-university_yellow-border

Instant photo x 1

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#1

Scissors x 1

instant-university_SFA1203-lecture-3-polaroid-impossible-emulsion-lift-workshop-#2

Soft paintbrush x 1

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#2

Hair-dryer x 1

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#3

Tray of hot water (around 70°C / 160°F) x 1

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#4

Carrier surface
instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#5

Acetate x 1

instant-university_SFA1203-lecture-4-fuji-emulsion-lift-workshop-#6

 

STEP-BY-STEPinstant-university_yellow-border

1. After taking a picture, pull film out and wait for like 1.5 minutes for full development. Then you can peel the negative image away from the positive.

2. Air dry the print until it is completely dry. Or use a hairdryer to speed up the drying process.

3. Cut all the white borders around the image.

4. Put the print face up into the hot water. Make sure the print is literally submerged. By rocking the trap back and forward, you will see some white bubbles appear on the image surface, and in about 4 minutes, the emulsion should start falling off from the print.

5. If the emulsion has not completely separating, pour some more hot water and continue the agitation. Use fingers to assist the separation, until the emulsion has totally come off.

6. Take a sheet of acetate and slide it under the emulsion, flatten the lift as much as you can.

7. Put the image on the carrier surface, at this time, the image should be in between of the carrier surface and the acetate.

8. Moisture the carrier with little water, put the acetate over the carrier where you want your image to be.

9. Carefully remove the acetate.

10. Apply the acrylic medium (glass gel medium is fine as well) with a small brush on the image area.

11. Air dry the finishing piece overnight and you are done!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

w

Connecting to %s